Author Topic: Any Rotary/PFC tuners in Michigan?  (Read 5623 times)

0 Members and 1 Guest are viewing this topic.

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Any Rotary/PFC tuners in Michigan?
« on: May 16, 2018, 06:50:50 AM »
Not sure if anyone is aware of any, the closest I can think of is Banzai, which is 4 hours away, which isn't too bad.
1986 AS GXL Turbo swapped
1993 VR R1

Offline awfc3s

  • Administrator
  • Rotary God!!
  • *****
  • Posts: I am a geek!!
  • Karma: 5
  • Gender: Male
  • ~Keep It Sideways~
Re: Any Rotary/PFC tuners in Michigan?
« Reply #1 on: May 16, 2018, 07:47:21 AM »
I don't know of any in Michigan. There's an RX7 shop (the Zoom-Zoom Store) here in Columbus, but from what I've heard, they are good at bolt ons and nothing more. Then there is Elite Rotary Shop in Chicago, which is where I will be taking the FD once I fix it.
'88 SE LSX (Dead)
'87 LSX drift car
'90 TurboII vert
'94 Silver Stone Metallic Touring

Offline ITSWILL

  • Rotary God!!
  • ******
  • Posts: I am a geek!!
  • Karma: 9
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #2 on: May 16, 2018, 07:49:11 AM »
We can just load what is in my PFC and take it to the dyno here in Pontiac for fine tuning
86 Base LS1 w/100 shot
88 TII 20B T70 turbo

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #3 on: May 16, 2018, 08:17:51 AM »
Do you know what secondaries you have? That'd be a great idea actually, as long as everything hardware matches. I found out there's an option on the PFC commander that allows you to switch to Non-SEQ mode.
1986 AS GXL Turbo swapped
1993 VR R1

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #4 on: May 16, 2018, 08:18:56 AM »
My car is wanting to boost to 14PSI right now, figured I'd need a tune eventually, but now I REALLY need one. The boost controller doesn't seem to want to work, which is me thinking it's boost spike.
1986 AS GXL Turbo swapped
1993 VR R1

Offline ITSWILL

  • Rotary God!!
  • ******
  • Posts: I am a geek!!
  • Karma: 9
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #5 on: May 16, 2018, 10:17:59 AM »
I really don't know about the injectors.  If anything it may have 850 primaries.  We can check it out though.  I have no boost controller and it runs at about 12 psi so I would assume your boost controller would only be able to make it higher.
86 Base LS1 w/100 shot
88 TII 20B T70 turbo

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #6 on: May 16, 2018, 10:48:54 AM »
I think the PFC has a way to control boost too, my car see's 14PSI if I let it now, which I've only done once, and won't again until it's tuned. I bet there's a way to up the boost on your car with the controller.

The boost setting was set at the half way point (which was 10PSI before the intercooler), I set it lower and it didn't do anything, which makes me believe it might just be boost spiking (cutback + high flow cat + intake + intercooler does that).

It would be nice if there's a way to upgrade the secondaries without upgrading the entire rail and fuel system, due to the side feed injectors.
1986 AS GXL Turbo swapped
1993 VR R1

Offline ITSWILL

  • Rotary God!!
  • ******
  • Posts: I am a geek!!
  • Karma: 9
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #7 on: May 16, 2018, 11:42:02 AM »
A boost controller doesn't generally make less boost than what the wastegate spring designates.  It usually PWMs the boost line to the diaphragm to reduce the boost pressure it actually sees.
86 Base LS1 w/100 shot
88 TII 20B T70 turbo

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #8 on: May 16, 2018, 01:50:07 PM »
Correct, but it should be able to hold it at 10psi then? I think it was a 7 or 10 lbs spring?
1986 AS GXL Turbo swapped
1993 VR R1

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #9 on: May 16, 2018, 02:36:08 PM »
Well, played with the controller and it's now boosting to 12PSI, which I'm happy with until I get a tune.
1986 AS GXL Turbo swapped
1993 VR R1

Offline ITSWILL

  • Rotary God!!
  • ******
  • Posts: I am a geek!!
  • Karma: 9
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #10 on: May 16, 2018, 02:51:09 PM »
Did you already get a PFC?
86 Base LS1 w/100 shot
88 TII 20B T70 turbo

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #11 on: May 16, 2018, 03:53:18 PM »
Not yet, probably will this week though.
1986 AS GXL Turbo swapped
1993 VR R1

Offline ITSWILL

  • Rotary God!!
  • ******
  • Posts: I am a geek!!
  • Karma: 9
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #12 on: May 16, 2018, 05:55:25 PM »
Sweet, what fuel pump is in the car?
86 Base LS1 w/100 shot
88 TII 20B T70 turbo

Offline murz

  • Hero Member
  • *****
  • Posts: 622
  • Karma: 7
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #13 on: May 17, 2018, 05:36:33 AM »
Supra fuel pump apparently.
1986 AS GXL Turbo swapped
1993 VR R1

Offline ITSWILL

  • Rotary God!!
  • ******
  • Posts: I am a geek!!
  • Karma: 9
  • Gender: Male
Re: Any Rotary/PFC tuners in Michigan?
« Reply #14 on: May 17, 2018, 06:49:16 AM »
Should be good to crank her up a bit then.
86 Base LS1 w/100 shot
88 TII 20B T70 turbo